jmvast.blogg.se

Refer to paragraph 2 of Appendix A for certain definitions.

Refer to Vehicle Standard (Australian Design Rule Definitions and Vehicle Categories) 2005.ģ.2. Vehicles certified to ADR 31/02 or a later version need not comply with this rule.ģ.1. For MB and MC category vehicles, manufacturers can choose to comply with this national standard in lieu of ADR 35/….Ģ.5. All other LEP vehicles must comply with ADR 33/….Ģ.4. For LEP vehicles, this national standard only applies to those fitted with a single foot pedal controlling both front and rear service brakes. This standard is binding on all new model MA and LEP category vehicles from 1 January 2004 and from 1 January 2006 for all vehicles in those categoriesĢ.3.1. This Australian Design Rule applies to the design and construction of vehicles as set out in 2.3, 2.4 and the table below.Ģ.3. This Australian Design Rule prescribes braking system requirements for passenger cars.Ģ.2. This Standard also repeals each instrument made under section 7 of the Motor Vehicles Standard Act 1989 that creates a vehicle standard with the name Australian Design Rule 31/01 - Brake Systems for Passenger Cars, if there are no other vehicle standards created by that instrument, or amendments to vehicle standards made by that instrument, that are still in force at the commencement of this Standard. (b) in force at the commencement of this Standard.Ġ.3.2. (a) made under section 7 of the Motor Vehicles Standard Act 1989 and This Standard repeals each vehicle standard with the name Australian Design Rule 31/01 - Brake Systems for Passenger Cars that is: This Standard commences on the day after it is registered.Ġ.3.1. This Standard may also be cited as Australian Design Rule 31/01 - Brake Systems for Passenger Cars.Ġ.2.1. This Standard is the Vehicle Standard (Australian Design Rule 31/01 – Brake Systems for Passenger Cars) 2005.Ġ.1.2.